1. The servo reducer must be installed with a vent cap. Before use, the blockage at a high position should be replaced with an exhaust plug to ensure that the gas is discharged from the body when the reducer is running. If it is not replaced in time, the reducer will run for a long time, and the gas in the reducer will swell the oil seal, and the reducer will leak oil.
2. It is strictly forbidden to install the servo reducer on the output shaft of the reducer. When couplings such as couplings, pulleys, sprockets, etc., direct hammering is not allowed, because the output shaft structure of the reducer cannot withstand axial hammering , You can use the screw hole in the shaft end to screw in the screw and press into the coupling piece.
3. Servo reducer timely replace lubricant, pay special attention to the first time.
Special attention should be paid to the first oil change. The reducer should replace the lubricating oil in time after 300 to 400 hours of the first run, and then replace the lubricating oil every 1500 to 2000 hours. In addition, in the working environment with harsh working environment, high temperature and heavy dust, the lubricating oil should be checked every half a month. If the lubricating oil is dirty, replace the lubricating oil to keep the lubricating oil clean and extend the servo reducer. Service life, improve economic efficiency.
Replacing the lubricant means: release all the previous lubricant, rinse it off, and then add new lubricant.
In summary, there are three points to be noted for the servo planetary reducer explained to you by Dongguan Jichuang Editor. In fact, we should pay more attention to these points, and there are other places to pay attention to. What is the specific editor today? I won't say it for the first time, and I will give you an answer one by one next time. I hope that the explanation above will help you. If you have any questions, please pay attention to Dongguan Jichuang planetary reducer manufacturers.
================================================== ================================================== ======
Rubber expansion joint system comprises of No.8 standard models designed to accommodate movement up to 330mm by shear deformation of the elastomer between the steel components. Each model of our rubber plate-type expansion joint incorporates steel angles designed to be bolted to the structural deck and a steel bridging plate system which spans the open joint gap. The elastomer case is highly resistant to oils, solvent spillage and the trafficked surface includes an anti-skid pattern for safety having a rubber to rubber coefficient of static friction of 0.69. Each model of bridge deck Rubber Expansion Joint is specifically designed to accommodate horizontal and skew movement and will also accommodate vertical movement due to rotation of up to 6mm.J.S Brown can supply many kinds of movements rubber expansion joints such as 30mm movement rubber expansion joint,50mm movement rubber expansion joint and so on.We have exported to many countries.
Rubber Expansion Joint
Rubber Expansion Joint,Single Ball Rubber Expansion Joint ,Flexible Rubber Expansion Joint,Customized Rubber Expansion Joint
J.S.Brown New Material Technology Co., Ltd. , https://www.profile-steel.com