First, the margin of water transport and product material margin is generally designed between 10MM-12MM; alloy mold is generally 25MM;
Second, the margins of transporting water and inserting pins, ejector pins, division cylinders and inserts are designed as follows:
The inner mold below 1200MM, the margin of water transport and the margin of inserting pin, ejector pin, division tube and inserts are not less than 3.5MM:
2 The internal model of 200MM-400MM, the distance between the edge of the transport water and the inserting needle, ejector pin, division tube and insert material shall not be less than 4MM;
3Inner moulds larger than 200mm-400mm, the margin of water transport and the margins of inserting needles, ejector pins, division cylinders and inserts shall not be less than 4mm;
4 The inner mold of more than 400MM-600MM, the edge of the transport water and the margin of inserting needle, ejector pin, department cylinder and insert are not less than 5MM;
5 The inner mold is more than 600MM, the margin of water transporting and the margin of inserting pin, ejector pin, department cylinder and insert are not less than 8mm;
Third, transport water and gas top, hydraulic circuit is not less than 8MM;
Fourth, transport water side and pry mouth to avoid the edge is not less than 8MM;
Fifth, transport water edge and inner mold edge is not less than 10MM;
6. The same direction distance design for transporting water and transporting water;
1 when the two pipe joints are in the same direction, the distance between the centers is not less than 38 mm;
2 When the joint is in the same direction as the throat plug, the closest distance to the center is not less than 25mm;
3 When the two laryngeal plugs are in the same direction, the closest distance to the center is not less than 20 mm;
4 large mold material bit area is larger, the same direction transport distance, the center distance is generally taken 60MM;
7. The distance between the aprons of the baffle plate is not less than 2mm; between the glottal plug and the glottal plug is not less than 5mm;
8. In general, no more than 8 spacers shall be connected in series for each water transport circuit;
Nine, the insert design cooling water, transport water and insert material position to maintain the closest distance 5MM; transport water and insert edge not less than 3.5MM;
This article is edited by Zhongshan Huashi Fushun Special Steel Technology Department. Please call for more details.
Contact: Mr. Chen 18988586811
Service Hotline
Address: Road 105, Pingdong Industrial Zone, Sanxiang Town, Zhongshan City, Guangdong Province
The UV coating of 5.0mm SPC Vinyl Flooring is another shield for the top layer of SPC Flooring , it contains ceramic components and make the surface scratch – resistant to different damage.
5.0MM SPC Vinyl Flooring also use UV layer to cover the decor film on SPC Vinyl Flooring to make it anti-fading to sun light near window or any other indoor environment.
That can adjust the shinning degree of flooring surface, after UV coating processing the degree of light reflecting on flooring surface can be perfectly adjusted to around 5-7 degree, and make the decor of spc flooring looks very real and elegant as solid wood.
5.0mm SPC Vinyl Flooring
5.0MM SPC Vinyl Flooring,SPC Vinyl Floor,SPC Vinyl Plank Flooring,Wood Plastic Vinyl Flooring
GreenOmni Surface Co., Ltd , https://www.greenomnifloors.com