Correction tips for closing the shaft hole

Home>Bearing knowledge>Revision tips for closing the shaft hole
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Correction tips for closing the shaft hole

Source: Bearing network time: 2018-05-13

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1) Detect the wear depth of the shaft hole; if the wear depth is less than 4mm in the diameter direction (ie, the radius direction is less than 2mm); use the electric tool to sharpen the surface to be repaired. Pay attention to: the outer surface should not be polished too much; the rougher the better; the external treatment The process is described in Chapter 3, §1 Appearance.
(2) Use the Keisin 1755 scavenger to remove the outer surface of the bearing hole.
(3) Apply a thin layer of Kesaixin 1731 release agent on the outer ring of the bearing; in order to facilitate the disassembly of the bearing in the future.
(4) Manufacturing 2311 antifriction repair agent.
(5) Apply the repairing agent directly to the outer ring of the bearing; but only apply to the rear half of the outer ring of the bearing. The amount of coating should ensure that there is no glue between the outer ring of the bearing and the shaft hole; The gap is completely filled.
(6) Push the bearing coated with the repair agent into the shaft hole.
(7) Wipe off the extruded repair agent. Again, when pushing the bearing, make sure that the repairing position is not lacking in glue.
(8) Position the bearing.
a. The simplest method is to install the shaft together with the bearing; after the accuracy is determined, the repair agent is cured in this direction.
b. Conditions can be used; can be positioned or installed by three-point gasket positioning method or manufacturing fixture.
(9) It can be put into use after it is completely cured.
Recommend to friends comments close window

Bearing related knowledge
Key skills in bearing production (2)
Inductive analysis: nine common causes of faults in the analysis of the use of high-rigidity SKF bearings, the selection of foreign mechanical occupational bearing heat treatment methods (below)


This article links to http://
Please indicate China Bearing Network http://

Previous:The disadvantages of bearing external grinding and the countermeasures: The protection of NSK bearing on the pump

Flame Retardant Polypropylene Film

Flame Retardant Pp White Film 10Mil,Lcd Display Insulation Layer,Car Inside Insulation Film,Car Battery Insulation Pp Film

Mianyang Prochema Commercial Co.,Ltd. , https://www.gustek.com

Posted on