Many people are not quite sure why the gas water heater can't fight the fire. The next ten possible reasons why Xiao Bian can not help you get the water heater out of the fire, and how it solves this is the way water heaters can't fight the fire.
1. One of the causes of the water heater not firing: power problems
Gas water heater can not solve the fire solution: check the AC power plug light is lit, first eliminate the power supply part of the problem.
2. The second reason that the water heater cannot reach the fire: Solenoid valve failure
Water heater cannot solve the problem: if only the ignition sound is heard when the ignition is on, there is no magnetic valve “嗒†magnetic absorption sound, it may damage or aging the solenoid valve, and the solenoid valve will be out of control when the ignition starts. Can pull on, play on fire, but then closed and extinguished; may also be gas pressure is too high or too low, the use of cylinder gas water heater will appear cylinder valve pressure is too high or too low to use the water heater can not be on fire It is more likely that the solenoid valve is dirty. Solenoid valves cannot pass gas, and gas (natural gas, liquefied petroleum gas, and artificial gas) cannot come out and cannot come out, causing no ignition. Before confirming that the solenoid valve is good or bad, check whether the igniter control circuit is normal. If there is a fault, the solenoid valve cannot be controlled to close.
3. The third reason for the failure of the water heater: the failure of the electric igniter
The solution for the water heater not working: The pulse igniter and the controller have a fault on one side, and the water heater cannot ignite.
4. The fourth reason for the failure of the water heater: ignition porcelain pin or induction porcelain pin problem
Gas water heater can not solve the fire of the solution: a. Ignition needle offset or aging is very difficult to fire, can be replaced or the ignition pin is properly placed; b. induction aging, can be placed on the sensor polishing (make the fire regardless of the fire or small The fire can fully burn the sensor needle).
5. The fifth reason why water heaters cannot reach the fire: water pressure problems
Gas water heater can not solve the fire solution: a. Water heater can not start normally when the water pressure is low;
b. The plugging of the filter at the water inlet causes the water to not flow properly and can be cleaned.
6. Sixth reason why the water heater cannot reach the fire: Water and gas linkage failure
Water heaters can not fight the fire solution: a. water vapor valve tympanic membrane aging or damage can not push the micro switch;
b. The micro switch is bad.
7. The seventh reason why the water heater is not on fire: The air source switch is not open or the inlet air filter is blocked
The solution to the problem that the water heater is not on fire: Open the air source and clean the air intake filter.
8. Eight of the reasons why the water heater is not on fire: gas does not match
Water heaters can not fight the fire of the solution: For example, the liquefied gas water heater received natural gas, etc., p This situation requires the liquefied gas water heater to change the gas before they can access.
9. Nine of the reasons why the water heater cannot reach the fire: Valve seals are corroded by gas and rise.
Water heaters can not fight the fire solution: replacement parts.
10. Ten Reasons Why Water Heaters Can't Fight: The Smoke Pipe Fails to Exhaust
Gas water heater can not solve the fire of the solution: a. Tobacco pipe plugged, clean smoke pipe plug; b. Smoke pipe is too long, not properly installed.
Experience with water heater brand Linne water heater gas water heater switch
Special Tungsten Carbide Products
Drilling bits Mining bits,Carbide Inserts Co., Ltd. , http://www.nscarbide.com